Subcategories

• Mercury-Mariner-Tracker-Force Outboard Decals

  DECAL DRY APPLICATION

  IMPORTANT: This document guides our dealers, boatbuilders, and company service personnel in the proper installation or service of our products. If you have not been trained in the recommended servicing or installation procedures for these or similar Mercury Marine products, have the work performed by an authorized Mercury Marine dealer technician. Improper installation or servicing of the Mercury product could result in damage to the product or personal injury to those installing or operating the product.
  NOTE:After completing installation, place these instructions with the product for the owner's future use.
  IMPORTANT: This decal set must be applied dry. Do not use a soap and water mixture to apply this decal set.

  Tools, Materials, and Surface Requirements

  Tools and Materials

  • Decal application squeegee (3M® Applicator PA 1 Gold - recommended)
  • Air release tool (3M Air Release Tool 391x) or a straight pin - used to remove trapped air bubbles
  • Clean microfiber towel (Meguiar’s® Supreme Shine Microfiber Towel - recommended)
  • Spray bottles and labels for each cleaning solution
  • Cleaning solution:
    a. Liquid dishwashing soap
    b. Isopropyl alcohol
    IMPORTANT: Identify each spray bottle of cleaning solution with a label.

  Surface Requirements

  Special attention is required when applying decals to certain surfaces, including primed, painted, and certain plastics. All
  painted surfaces must be cured per the manufacturer's requirements. When applying decals to plastic surfaces, allow proper
  time for out gassing.

  Surface Preparation

  Application Temperature

  Apply the decal when the surface and ambient air temperature is between 16-373 °C (61-99 °F).
  NOTE: Applying the decal near the minimum temperature specification, the adhesive bond will develop more slowly than temperature in the mid to upper specification range.

  Step One General Cleaning

  IMPORTANT: Do not shortcut the cleaning process. All of the surfaces are considered contaminated prior to a thorough
  surface cleaning preparation.

  1. Mix a solution of 29.5 cc (1 fl oz) liquid dishwashing detergent with 3.7 Liter (4 US qt) of warm water.
  2. Rinse cowl with clean water.
  3. Dry the cowl with a clean Meguiar‘s Supreme Shine Microfiber Towel.
  4. Avoid detergents or preparations that contain waxes, oils, or lotions.

  Step Two Solvent Cleaning

  1. Mix a solution of isoprooyl alcohol and water to a 1:1 ratio. Store in a spray bottle and identify the solution with a label.
  2. Saturate a clean paper towel with the isopropyl alcohol and water solution.
  3. Wipe the cowl with the saturated towel followed immediately with a lint-free towel before the solution evaporates.
  NOTE: Isopropyl a/coho/ evaporates quickly. You must Wipe the surface immediately after applying the solution.
  4. When the paper towel becomes contaminated with dirt, discard it and use a clean paper towel saturated with the
  isopropyl alcohol and water solution.
  5. Ensure the surface has no contamination and is completely dry.
  6. Start to apply the decals immediately after solvent cleaning.

  Decal Application

  Application Tips

  1. Ensure that the surrounding work area and the surface are properly cleaned to avoid contamination.

  90-8M0143239 eng MARCH 2018       © 2018 Mercury Marine      -     Page 1 / 16

• Evinrude-Johnson Outboard Decals
• Nissan-Tohatsu Outboard Decals
• Yamaha Outboard Decals
• Suzuki Outboard Decals
• Honda Outboards